It mainly relies on the visual system and control system. The visual system captures the image of the product through a camera, and the light source provides sufficient illumination to ensure image quality. The image acquisition card converts the image into a digital signal, and then extracts the position information of the product through image processing software. The control system generates control signals based on this information to control the actuator of the dispensing machine for precis

Comparison between gear pump and screw pump: Both belong to positive displacement pumps, so their performance is basically similar - they can stably transport high viscosity substances and both have higher conveying pressure. However, the screw pump has a major drawback that determines its unsuitability

After manual feeding, the product is automatically filled with glue online for the first time, vacuumed, and then filled again. Finally, it flows into the oven, and after baking, the fixture board automatically flows back through the elevator. Repeatedly cycling integrated glue filling.

1. Check if the surface of the equipment is clean and if there are any obvious adhesive residues. 2. Before the homework, was the AB glue weighed and confirmed that the actual total amount of AB material discharged matches the set value. 3. Check the power supply of the equipment and ensure that the wire connections are normal. Also, check if the plug of the wire body is damaged

Vacuum glue filling machine is a device used in the fields of electronic components, optoelectronic components, automotive parts, etc. Its principle is to use the pressure difference under vacuum state to evenly pour glue onto the surface or interior of the product, in order to achieve sealing, fixing or thermal conductivity effects. Below, we will provide a detailed introduction to the working principle of the vacuum glue filling machine.